|
|
![gaming_screwlength1](https://cdn-daily-blog.adafruitdaily.com/uploads/2015/11/gaming_screwlength1.jpg)
Test-fit screws in the interior mounting holes. You may (or may not) find that they only go in a couple millimeters.
There is so much variation among printers, filaments and slicer settings, it’s not always possible to make a perfect mechanical fit for all situations.
If the holes are too shallow, use a drill or Dremel tool to extend them. Poke just through the surface to the infill…don’t drill the whole depth or you’ll punch out the other side.
|
|
|
| |